Agam 0 Posted October 12, 2016 Share Posted October 12, 2016 Hi, I am new to CC3200. Actually I want to use the Uart of cc3200. My application is to read data from a serial transmitter of another device using CC3200 and print the data on the serial monitor of Energia. I saw that there are two kinds:- Serial and Serial1. Can I use serial1 to read the data and then print data on serial monitor of Energia using Serial. Do I need to shift the J6,J7 from flash mode to BP mode?? I have seen the pinmapping. In that I found that Serial 1 is connected on UART1_Rx on GPIO11 i.e. P1-10 of CC3200 launchpad. Do I need to connect the peripheral devices' Tx pin on P1-10 and then print the data on Serial monitor using Serial.write(); ?? Quote Link to post Share on other sites
hungtran 0 Posted October 12, 2016 Share Posted October 12, 2016 Hello. I need to use the watchdog for cc3200(WiFi) but I can not find any information about it. Can someone help me please? Quote Link to post Share on other sites
Sam123 0 Posted May 8, 2020 Share Posted May 8, 2020 I have the same problem. DId you find a solution to this? Thanks. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.