Jump to content

Recommended Posts

I am running into a little bit of an issue at the moment. 
Following the schematics in the F28069M dev board I have set the JP7 off and JP6 on. These two jumpers I believe are the Mux values that would enable the Serial pins to use SCI.


Looking at the pin map out on the F28069M launchxl dev kit I chose 19 and 7 for the bluetooth module. 


When I use the serial monitor or a blueterminal on my android device, I am not getting any response. 

Maybe someone in here can shine some light into my problem. 



Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...