Jump to content

Tiva C Series LaunchPad Based Digital Oscilloscope with Labview Interface

Recommended Posts

TivaScope is an oscilloscope which works with Tiva Launchpad (http://www.ti.com/tool/ek-tm4c123gxl, only 12.99$) from Texas Instruments. It communicates with PC via USB port. Its maximum sampling frequency is 1MSa/s with 12bit resolution. The signal which is shown on screen was obtained from referance signal output with10KHz %30 Duty Cycle. It also supports Stellaris LM4F120 LaunchPad.

  • Maximum sampling frequency is 1MSa/s with 12bit resolution.
  • It supports USB 2.0
  • Single channel input PE3(AN0)
  • Referance signal output with10KHz %30 Duty Cycle from PB6
  • Labview Interface


Link to post
Share on other sites

Dear L.R.A, I don't have any problem with internal ADC, I tested it during 8 hours it works good. Actually I think it. Using the external ADC chips will provide to reach high resolutions and sampling rates. I have some ADC chips to do it, if I can find more free time, I will try on it. But the first aim is here that converting the Tiva LaunchPad to low cost scope so I did not use any extra component, only coding.

Link to post
Share on other sites
  • 5 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...