nitred 2 Posted February 5, 2015 Share Posted February 5, 2015 Hi, there's several occasions where I need a reset so that my program can start all over again. Is it possible to do this from the code directly? Thanks! Quote Link to post Share on other sites
MMKC 0 Posted February 5, 2015 Share Posted February 5, 2015 Just Jump out SOP2This jump just for Forced AP mode or using UniFlash Quote Link to post Share on other sites
Fred 453 Posted February 5, 2015 Share Posted February 5, 2015 I think maybe what you're after is a way for your software to restart your code from the beginning. The easiest way is cause a watchdog fault by writing to the watchdog with the incorrect password. I'm not in a position to lookup the exact code for you right now though. Quote Link to post Share on other sites
nitred 2 Posted February 10, 2015 Author Share Posted February 10, 2015 Thanks for this, I'll look up the code myself and see if I can post the results here. I wonder though if I can connect a pin to the SOP2 and pull that pin up to reset the board. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.