I2C on CC3200

[MikeSchem 0]

I have been attempting to work with serial communication between the board and other devices, but cannot get them to communicate while on connected to the booster pack rails.  The only time I have ever gotten any Serial communication to work is by connecting a UART device to J6 & J7 in the middle.  Is there a different Pin configuration I need to get those to work?  I switched the jumpers on J6 & J7 down after downloading my code to the CC3200.

[energia 485]

There is a pinmap posted on Energia.nu that might help you.

http://energia.nu/pin-maps/guide_cc3200launchpad/

 

I2C is on pins 9(SCL) and 10(SDA). The UART on the header pins is on 3(RX) and 4(TX). Note that this uart is address with Serial1.xxx. Serial.xxx the UART that ends up on the USB connector that you connect to your PC.

[amirchaudhary 0]

I have interfaced accelerometer sensor using energia but not able to program the temperature sensor on CC3200 launchpad but not able to connect the compiler shows the following error

 

 C:\Program Files\energia-0101E0013\hardware\cc3200\libraries\Adafruit_TMP006\Adafruit_Sensor.cpp:2:26: fatal error: avr/pgmspace.h: No such file or directory

compilation terminated. 

 

but this was solved wen i copied the adafruit library but again a new error 

C:\Program Files\energia-0101E0013\hardware\cc3200\libraries\Wire\utility\twi.c:25:20: fatal error: avr/io.h: No such file or directory

compilation terminated.

 

i am not able to solve it not getting any clue for it 

please guide!!!!