Jump to content
43oh

I2C_Scan_Problem


Recommended Posts

Hello everyone.I am trying to learn I2C device adress of my MPU6050 sensor by using Ardunio I2C scan code in Energia.But although the code doesn't give me any error,on serial monitor I see all registers from 0x01 to 0x7E.I should see one register but I see all register on serial monitor like below...

Scanning...
I2C device found at address 0x01  !
....
....
....
I2C device found at address 0x7D  !
I2C device found at address 0x7E  !
done
 
The code that I have used is http://playground.arduino.cc/Main/I2cScanner.
 
I am sure about connections between my sensor and my msp430g2553.I used 4.7k pull up resistors with SDA and SCL pins.
 
What do you think about my problem ? 
Thanks in advance.
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...