Jump to content
LariSan

LaunchPad Proto Plate- from Ponoko

Recommended Posts

I couldn't see any in the UK at first but noticed that Rapid stock them so I've now ordered one. (To answer the original question they're: 83.5 x 54.5 x 8.5mm).

Share this post


Link to post
Share on other sites

I'm a bit late to this party but...

 

Here's mine:

Lasered by own stand-offs and cut some holes in the sled for those to fit in. Tossed a couple of graphics on it. My stand-offs fit the holes loosely enough to fall out when they are not holding a board. Snapping in a board puts enough tension on the 'ankles' to hold them in very snuggly by friction. Cyanoacrylate (super glue) or plastic cement will hold the stand-offs permanenty. Board can be pulled out if the stand-offs are not glued to the sled - or they can be snapped out by *carefully* pulling back on the 'peaks' of the stand-offs.

 

I cut 4 extra stand-offs, just in case I fail to be *carefull*. My laser is 50 watt with a 20" x 12" max material size.

 

Without glueing the stand-offs, mine is holding just fine while actually working with it.

 

post-30258-0-32354900-1387205613_thumb.jpg

post-30258-0-72244700-1387205618_thumb.jpg

post-30258-0-20909400-1387205622_thumb.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...