Jump to content
LariSan

LaunchPad Proto Plate- from Ponoko

Recommended Posts

I couldn't see any in the UK at first but noticed that Rapid stock them so I've now ordered one. (To answer the original question they're: 83.5 x 54.5 x 8.5mm).

Share this post


Link to post
Share on other sites

I'm a bit late to this party but...

 

Here's mine:

Lasered by own stand-offs and cut some holes in the sled for those to fit in. Tossed a couple of graphics on it. My stand-offs fit the holes loosely enough to fall out when they are not holding a board. Snapping in a board puts enough tension on the 'ankles' to hold them in very snuggly by friction. Cyanoacrylate (super glue) or plastic cement will hold the stand-offs permanenty. Board can be pulled out if the stand-offs are not glued to the sled - or they can be snapped out by *carefully* pulling back on the 'peaks' of the stand-offs.

 

I cut 4 extra stand-offs, just in case I fail to be *carefull*. My laser is 50 watt with a 20" x 12" max material size.

 

Without glueing the stand-offs, mine is holding just fine while actually working with it.

 

post-30258-0-32354900-1387205613_thumb.jpg

post-30258-0-72244700-1387205618_thumb.jpg

post-30258-0-20909400-1387205622_thumb.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×