pine 140 Posted June 2, 2012 Share Posted June 2, 2012 This has been long time since i wanted to do something with a sample from TI (thanks TI!) that included an SMD version of MSP430F2003. I tried to solder thin wire cut from burnt LEDs, but my skill or gear is far from the level to finish the job. They doesn't stick well or simply fall off after awhile.. So recently read something about using the graphite on pencil, which is conducting material, to form part of a circuit. Following the concept and some very crude testing (lit an LED), i tried to connect the Vcc, GND, TEST, and RST to that small chip in an attempt to program it, by drawing a pencil-pcb on a Starbuck coupon: Unfortunately the goddess of Starbuck did not smile at me this time CCS keep saying it can't connect or is not a recognized device. Maybe someday I'll find a way to make use of these two little chips larsie and RobG 2 Quote Link to post Share on other sites
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.