Jump to content
swathisk

cc3200 for gps location

Recommended Posts

even after uploading the code to cc3200 launchpad interfaced with neo 6m gps module without any error the serial monitor does not display any values... can i know how to sort this out...

 

Share this post


Link to post
Share on other sites

hi swasthisk,

first do one thing, disconnect the gps module from your cc3200 then connect the gps with ttl to usb module for check the gps is working or not. if you already done this step kindly ignore it. 

after get the result of gps module working state then move to code section, kindly check the uart (gps connected port)baud rate in your program, neo gps module default baudrate is 9600,

then check the connection 

NEO GPS module                                                   cc3200

tx                                                                                     rx

rx                                                                                     tx 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×