lensdigital 0 Posted February 14, 2019 Share Posted February 14, 2019 I've obtained a board with CC1330 IC that's not launchpad (it's E70 constellated module). It basically has all the power management, antenna port and access to almost all ports. I would like to use Energia IDE to program it, but not sure how. Can I just use FTDI type USB to Serial converter and connect it to chip's UART TX/RX/Reset ports? Basically how would you program CC1330 that's not on Launchpad? I'd appreciate any info I can get :) Quote Link to post Share on other sites
energia 485 Posted February 14, 2019 Share Posted February 14, 2019 Interesting. I did not know about these modules. Thank you for bringing this to my attention. Which module do you have (frequency)? These module are intended to be used as a network processor connected to an MCU. Looking at the user manual there is no serial loader implemented nor a way to update the firmware over the air. With that said, it seems that the modules expose the TCKC, TMSC and RESET line. You should be able to hookup these lines from the LaunchPad's XDS110 if you have one to program it with Energia. Please not that there are pin mappings specific for the LaunchPad that you might want to change. lensdigital 1 Quote Link to post Share on other sites
lensdigital 0 Posted February 14, 2019 Author Share Posted February 14, 2019 Thanks! I got 915Mhz version (915T14S). I might have to get Launchpad to utilize XDS110.... Can I use my ISP programmer i stead? These are awesome, very small. Kind of like ESP8266 but sub 1Ghz Quote Link to post Share on other sites
energia 485 Posted February 15, 2019 Share Posted February 15, 2019 Which ISP programmer do you have? If it's compatible with CC1310 then we should be able to figure something out. Quote Link to post Share on other sites
lensdigital 0 Posted February 15, 2019 Author Share Posted February 15, 2019 49 minutes ago, energia said: Which ISP programmer do you have? If it's compatible with CC1310 then we should be able to figure something out. I got "Pololu USB AVR Programmer v2"... I guess it won't work, since it's for AVR chips I ordered Launchpad, so I'll program it thru it's XDS110... How would I program secondary chip via Launchpad btw? Will it program both in parallel or I can specify somehow? Sorry I never used JTAG before Look how small this module is So much more practical lol Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.