Jump to content

PCB Calculator Programs

Recommended Posts

I thought we should have a post that we collect useful PCB guidelines, tips, tricks and calculators in.


Here's some contributions:


1. UltraCad's PCB Calculators and Tools

2. Saturn PCB Design Toolkit

3. High Speed USB Platform Design Guidelines

4. Dave Jones' PCB Layout Tutorial

5. TI's PCB Design Guidelines For Reduced EMI

6. Altera's High-Speed Board Layout Guidelines

7. SMPS' Power Supply PCB Design Guidelines

8. Maxim's General Layout Guidelines for RF and Mixed-Signal PCBs

9. High Voltage PCB Design

10. Op Amps for Everyone - Chapter 17: Circuit Board Layout Techniques


I think I touched on most of the important design topics. Low noise A2D pcb design is one I didn't track down yet.

Share this post

Link to post
Share on other sites

How relevant are these pcb calculators? Just curious cause i've never really seen the need for one yet. Granted i'm still quite new to all this.


Do you guys really run into issues with your hobbyist projects where trace impedance or trance inefficiencies at high frequencies are really an issue?

Share this post

Link to post
Share on other sites

Yes! Emphatically YES!


You'll need to craft a 50 ohm trace from your RF module out to the antenna connector. How are you going to do that? What are the proper dimensions for that trace? Unless you know the dimensions already, you ain't gonna know.


What happens to the impedance of that trace when you decide that you need a 0.100" thick PCB instead of a 0.062" PCB? Just plug the dimensions into the calculator and out pops your routing information.


Another scenario that you alluded to is high speed differential traces. Granted, I doubt they would ever be used on an MSP430 but I've had to use them on FPGA designs where I was trying to get data in and out of the chip at 600MHz! It's a combination of RF and Transmission Line theory at that point. If you upset the impedance of those tracks with a misplaced 0603 resistor then BLAMMO you're dead in the water and you've wasted $2000 or more on your PCB.


It's all about signal integrity. You have to find it and struggle to keep it. There's an entire industry built up around SI and PCB layout.

Share this post

Link to post
Share on other sites
On 4/9/2013 at 11:26 PM, PolkaDot said:

While we're here, can you recommend or link to any recommended software packages?

Much appreciated  :smile:  

We (San Francisco Circuits) wrote a pretty massive PCB design software comparison article that compares 5 of the top CAD packages.

And, along the lines of high speed design tips, our RF PCB manufacturing page has a handy table of RF material selection based on application/industry.

Share this post

Link to post
Share on other sites


This Javascript web calculator calculates the trace width of printed circuit board conductors for a given current using formulas from IPC-2221. Other options that Calculator consists are as following:


Track Width

Electrical Spacing

Trans Line

RF Attenuators

Color Code

Board Classes

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...