Jump to content
43oh

CC1310 Micros problem on TI LaunchPad


Recommended Posts

Hi All,

I am trying to measure some timing properties of a protocol I have written that uses the EasyLink library.

I was using micros() before and after I perform a send, which also waits for an acknowledgement. In addition to capturing micros() I am toggling a pin so I can see how long the event takes on the scope, and when the corresponding events happen on the other CC1310.

micros tells me the event took ~1400uS, however I measured about 33ms on the scope, I then replaced micros with millis() in my code and I am getting 33ms from that as well.

I would really like to be able to measure with sub ms accuracy, but micros just seem to report the incorrect value. Can anyone offer any assistance with how I can get micros working properly with the CC1310 LaunchPad?

Regards,

-Steve

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...