Jump to content
43oh

Recommended Posts

I would like to seek help in programming MSP430G2201.

That I am new to MCU field and it is my  first attempt to work with these, I have used Launch Pad to program some flash on other MCU but while trying to do on MSP430G2201 I have not succeeded. My trial is enumerated below.

I am using Launch pad to program MSP 430G2201 using TIDA-00386 remote code.

Upon Build when I click on Debug message as below appears. 

 

Error connecting to the target:

Could not find device (or device not supported)

 

I have connected Vcc, Gnd, RST and TEST pins of 2201 to the Launch Pad J3. I checked and confirmed correct connections offor Vcc and Gnd  on Pin # 14 and 1 of 2201 and so also the RST and TEST are connected correctly..


I have tried the above with CCS version 7 and earlier with version 6.2.

 

Target device is correctly configured as MSP430G2201 in CCS, USB port is also configured.

 

I have attached herewith two snap shots of wave forms of RST (Purple trace, channel 6 ) and TEST ( Grey trace channel 7). Both signals swing between 3.6 V and ground.

 

I seek you help so as to know where I may be going wrong.

 

Thanking you in anticipation.

J. A.

 

debug-start.JPG

 

debug-before-error-message.JPG

 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...