Jump to content

Search the Community

Showing results for tags 'current limit'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News
    • Announcements
    • Suggestions
    • New users say Hi!
  • Spotlight!
    • Sponsor Spotlight
    • Sponsor Giveaways
  • Energia
    • Energia - MSP
    • Energia - TivaC/CC3XXX
    • Energia - C2000
    • Energia Libraries
  • MSP Technical Forums
    • General
    • Compilers and IDEs
    • Development Kits
    • Programmers and Debuggers
    • Code vault
    • Projects
    • Booster Packs
    • Energia
  • Tiva-C, Hercules, CCXXXX ARM Technical Forums
    • General
    • SensorTag
    • Tiva-C, Hercules, CC3XXX Launchpad Booster Packs
    • Code Vault
    • Projects
    • Compilers and IDEs
    • Development Kits and Custom Boards
  • Beagle ARM Cortex A8 Technical Forums
    • General
    • Code Snippets and Scripts
    • Cases, Capes and Plugin Boards
    • Projects
  • General Electronics Forum
    • General Electronics
    • Other Microcontrollers
  • Connect
    • Embedded Systems/Test Equipment Deals
    • Buy, Trade and Sell
    • The 43oh Store
    • Community Projects
    • Fireside Chat
  • C2000 Technical Forums
    • General
    • Development Kits
    • Code Vault
    • Projects
    • BoosterPacks


There are no results to display.

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start



Website URL





Found 1 result

  1. I'm trying to drive an NTE108 (BJT NPN) with an output pin on my MSP430G2553 and having trouble. The output (P2.4) of the MSP is connected to the base of the BJT through a 330 resistor and controlled via software on the MSP. I've attached a picture of the schematic (R1 is a recent addition). Pin P2.4 works as expected when connected to the LaunchPad. It can drive an LED and works when floating. I cannot test it with the BJT (NTE108) because I only have one and it is soldered down. I have moved the MSP over to a protoboard where it is supplied with a 3V regulator that can do 250mA. Now the problems start... P2.4 floats somewhere between 0.5V and 1.5V all the time. It has not been configured in software for pullup/pulldown resistors. It seems like there is some activity when the pin should change from the software, but the voltage variation is minimal. If the base resistor R10 is disconnected from P2.4 and connected directly to Vcc (3V), it turns on the transistor as expected and the motor runs. >> Maybe the MSP cannot supply the current to turn on the BJT... If the base resistor R10 is disconnected from the MSP430, the pin floats near 1.0V regardless of software control (should be 3 or zero). If R1 is disconnected, the same happens.>> Not a current supply problem. I have checked that the chip is properly grounded and receiving adequate power. I have moved the chip back to the LaunchPad and everything still works fine. Any thoughts on why the pin is floating and cannot be controlled? This is driving me crazy. I only have problems on the protoboard so it's probably something to do with connections, but I've tried to check what I can. Is there something I'm missing about moving the MSP430 from a LaunchPad to a protoboard? Thanks, Danny
  • Create New...