Search the Community
Showing results for tags 'Getting Started'.
I'm trying to get started w/ the MSP Launchpad using the Energia blink example. I have Win 7 SP1 64 bit and the MSP-EXP430F5529LP. I haven't done anything to the board except plug it into USB. The green light is always on. When I try and upload the blink example the red light flashes once and then about a second later it flashes a lot for about three seconds and then gives one last flash. I've added in the log below. I'm sure its something stupid I'm doing or not doing. Is there a run command that goes after upload? I get the same result with either COM4 or COM5 (the two por