Jump to content

Search the Community

Showing results for tags 'Custom'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • Announcements
    • Suggestions
    • New users say Hi!
  • Spotlight!
    • Sponsor Spotlight
    • Sponsor Giveaways
  • Energia
    • Energia - MSP
    • Energia - TivaC/CC3XXX
    • Energia - C2000
    • Energia Libraries
  • MSP Technical Forums
    • General
    • Compilers and IDEs
    • Development Kits
    • Programmers and Debuggers
    • Code vault
    • Projects
    • Booster Packs
    • Energia
  • Tiva-C, Hercules, CCXXXX ARM Technical Forums
    • General
    • SensorTag
    • Tiva-C, Hercules, CC3XXX Launchpad Booster Packs
    • Code Vault
    • Projects
    • Compilers and IDEs
    • Development Kits and Custom Boards
  • Beagle ARM Cortex A8 Technical Forums
    • General
    • Code Snippets and Scripts
    • Cases, Capes and Plugin Boards
    • Projects
  • General Electronics Forum
    • General Electronics
    • Other Microcontrollers
  • Connect
    • Embedded Systems/Test Equipment Deals
    • Buy, Trade and Sell
    • The 43oh Store
    • Community Projects
    • Fireside Chat
  • C2000 Technical Forums
    • General
    • Development Kits
    • Code Vault
    • Projects
    • BoosterPacks

Calendars

There are no results to display.


Found 2 results

  1. Hi, I am trying to modify some of the core Energia files (main.c) so that I can initialize GPIO pins to LOW right away before Energia goes through its startup sequence. I have an LED driver connected to the MSP430FR5739 experimenter board (v1.1). The issue is, during the startup sequence (before my setup() code is running) the control pin from the experimenter board to the LED driver is active high for a few seconds thus turning the LED to full brightness. I would like to avoid using an external resistor if possible. My question is: 1. Is there a better way to initialize GPIO pins in Energia before the startup sequence? 2. I tried modifying main.cpp (under xxx\energia-1.6.10E18\hardware\energia\msp430\cores\msp430), but the changes didn't seem to reflect when I compiled my code with Energia. I even tried putting erroneous statements intentionally to see if this cause the compilation to fail, but it didn't do anything. Is this the correct file? Or does this version of Energia not allow modifications to core files? Thank you! Hardware: MSP430FR5739 Experimenter board v1.1 Energia Version: 1.6.10E18 OS: WIndows 7
  2. Hi, Is it possible to add a custom board/ circuit to energia? If yes, please guide me with the procedure for the same. Thanks
×