Search the Community
Showing results for tags '7-segment display'.
Hi, I was working on interfacing my MSP430 with a 4x4 keypad and I stumbled upon this application report. Then I looked into the specific low power modes of the F5529 and noticed that there was a LPM4.5. The application report uses LPM4 as it isn't the same device, and I was wondering if it was possible to use LPM4.5 as the device was waiting for keypad input as my goal is to minimize power usage.
Hi, I'm having a lot of trouble figuring out how to communicate with this Adafruit 7-segment display. I've looked through the Adafruit LED library, seen non-MSP microcontrollers working with the code, tried understanding the HT16K33 datasheet. I've even recorded the SCL and SDA signals from my Arduino connecting with the 7-segment. However, I'm still not sure how to get it to work with my MSP430G2553 or even how to get started. Though, I have looked into the MSP430 example code for i2c communications with the MSP430 as the master. Is it as simple as just converting the Adafruit LED l
Hello! My library for interacting an MSP430g2553 with a TM1638 (SPI 3-wire mode) Description MSP430G2xx3 - USCI_A0 SPI Master Interface to TM1638, Read/Write command, key scanning, show digit and switch LEDs on board. TM1638 - Driver for Led's indicator, 10 segment output lines, 8 grid output lines, 8 segment/key - 3 lines scanning. Features Support for the TM1638; Support for dimming the display and LEDs; Reading simultaneous button presses Connection diagramm: Code: #include "msp430g2553.h" // MSP430 Ports Define #define LED_RED BIT0 //RED Led #define LED_GRE BIT6 //Green Led #def