Search the Community
Showing results for tags '5529'.
Found 2 results
-
G'day, some port bits get set before the setup() can clear them. The same condition happens with the Blink sketch. The first lines in setup() are P6DIR = 0xFF; P6OUT = 0x0; P3DIR = 0xFF; P3OUT = 0x0; And after setup() has run the outputs are correct and the sketch works 100% But for a brief moment before setup() runs for the first(and only time) I get a few bits set on the port. Normally it would not matter but the ports are used to vary the volume and I get a thump each time I switch on. Also when reset switch is pressed (and held down)the same port bits switch high
-
I'm trying to connect to a camera (Adafruit's VC0706) via SoftwareSerial to a MSP430F5529, and the camera is only able to transmit and receive at 38400 baud. The board is able to transmit at 38400 successfully and receives a datastream back from the camera at 38400, but it is only displayed as gibberish on Energia's serial monitor. I know the camera isn't transmitting gibberish because it gives an identical signal to an Arduino, which displays it correctly, but I'm not sure what else to do. I saw on this forum that different boards sometimes have limits to the baud rates they can interpret,
