Jump to content


  • Content Count

  • Joined

  • Last visited

  • Days Won


lef2020 last won the day on October 8

lef2020 had the most liked content!

About lef2020

  • Rank
    Noob Class

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I'v solved this issue installing previous version of Energia. It's works. Release version 1.8.7E21 (10/17/2018) upload correctly.
  2. Release version 1.8.7E21 (10/17/2018) upload correctly.
  3. I have the same problem. On Linux, lunchpad MSP430G2, MCU 430G2553 Here error message: === Energia: 1.8.11E23 (Linux), Плата:"MSP-EXP430G2 w/ MSP430G2553" Скетч использует 380 байт (2%) памяти устройства. Всего доступно 16384 байт. Глобальные переменные используют 20 байт (3%) динамической памяти, оставляя 492 байт для локальных переменных. Максимум: 512 байт. MSPDebug version 0.24 - debugging tool for MSP430 MCUs Copyright (C) 2009-2016 Daniel Beer <dlbeer@gmail.com> This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. Chip info database from MSP430.dll v3.3.1.4 Copyright (C) 2013 TI, Inc. Trying to open interface 1 on 115 rf2500: warning: can't detach kernel driver: No data available Initializing FET... FET protocol version is 30394216 Set Vcc: 3000 mV Configured for Spy-Bi-Wire Sending reset... Device ID: 0x2553 Code start address: 0xc000 Code size : 16384 byte = 16 kb RAM start address: 0x200 RAM end address: 0x3ff RAM size : 512 byte = 0 kb Device: MSP430G2xx3 Number of breakpoints: 2 fet: FET returned NAK warning: device does not support power profiling Chip ID data: prog: '/tmp/arduino_build_265623/sketch_oct08a.ino.hex': No such file or directory ver_id: 5325 ver_sub_id: 0000 revision: 00 fab: 60 self: 0000 config: 00 Device: MSP430G2xx3 Произошла ошибка при загрузке скетча Этот отчёт будет иметь больше информации с включенной опцией Файл -> Настройки -> "Показать подробный вывод во время компиляции" ==================
  • Create New...