Jump to content

raziehashim

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. Hi, So I simply wanted to try out my new CC3220SF using Energia. Unfortunately I noticed that I always get the wrong readings from the pin. I used a voltage divider to ensure the voltage connected to the analog pin is no more than 1.3V. For that I simply took three 1k Ohm resistors and put them in series then connect a parallel circuit from the last resistor to the potentiometer. I also have ensure that the jumper powering the opAmp to enable the ADC on board is populated. I simply used the example code then changed the pin number. I also already have tested changing all the pin number but it all comes down to nothing. But to simplify your work to help me, here's the code nonetheless, void setup() { // initialize serial communication at 9600 bits per second: Serial.begin(9600); // msp430g2231 must use 4800 } // the loop routine runs over and over again forever: void loop() { // read the input on analog pin A3: int sensorValue = analogRead(A0); //I tried A0,A1,A2,A3 already // print out the value you read: Serial.println(sensorValue); delay(1); // delay in between reads for stability } And here is my setup: LaunchPad board name and version: CC3220S_LAUNCHXL (Rev-A) Energia IDE version: 1.8.11E23 Board package version: 5.6.2 OS name and version: Windows 10 Thanks, Razi Hashim
  2. I know this a quite an old topic. But I have two codes that I need to compile together. One code is written by using Energia, and the other is written on CCS. So I was wondering is there in any way for me to compile those two together.
×
×
  • Create New...