Hello, It's my first time using Energia and I am trying to figure out what the error is I got when I tried to upload the Blink code onto my MSP430G2553. I followed the steps in the installation guide, activated the TI udev rules, and tried restarting the computer. This is the error I got: Energia: 1.8.11E23 (Linux), Board: "MSP-EXP430G2 w/ MSP430G2553" /home/phys319/pir/energia-1.8.10E23/hardware/energia/msp430/cores/msp430/atof.c: In function 'atof': /home/phys319/pir/energia-1.8.10E23/hardware/energia/msp430/cores/msp430/atof.c:71:9: warning: floating constant exceeds range of 'double' [-Woverflow] Sketch uses 810 bytes (4%) of program storage space. Maximum is 16384 bytes. Global variables use 20 bytes (3%) of dynamic memory, leaving 492 bytes for local variables. Maximum is 512 bytes. MSPDebug version 0.24 - debugging tool for MSP430 MCUs Copyright (C) 2009-2016 Daniel Beer <firstname.lastname@example.org> This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. Chip info database from MSP430.dll v22.214.171.124 Copyright (C) 2013 TI, Inc. Trying to open interface 1 on 002 rf2500: warning: can't detach kernel driver: No data available Initializing FET... FET protocol version is 30394216 Set Vcc: 3000 mV Configured for Spy-Bi-Wire Sending reset... Device ID: 0x2553 Code start address: 0xc000 Code size : 16384 byte = 16 kb RAM start address: 0x200 RAM end address: 0x3ff RAM size : 512 byte = 0 kb Device: MSP430G2xx3 Number of breakpoints: 2 fet: FET returned NAK warning: device does not support power profiling Chip ID data: ver_id: 5325 ver_sub_id: 0000 revision: 00 fab: 60 self: 0000 config: 00 Device: MSP430G2xx3 prog: '/tmp/arduino_build_663674/Blink.ino.hex': No such file or directory An error occurred while uploading the sketch This report would have more information with "Show verbose output during compilation" option enabled in File -> Preferences. Does anyone have a solution to this? Please let me know and thanks!