Jump to content

buerni

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. buerni

    MSP430 Serial Monitor not working

    Thank you for your response! I've just seen that the core on my LaunchPad is a G2553, so i turned the J3 Jumpers horizontal as you have mentioned. I also added a delay, it still does not work. I can you provide you some pictures and screenshot if that helps.
  2. Hello guys, I just got into the world of MSP but am facing a disturbing problem since hours: The Serial Monitor stays clear no matter what I am doing. I own a MSP430G2452IN20 Launchpad Rev 1.5, all J3-Jumpers are vertical. I did try both USB 2.0 and USB 3.0. I did try alternative Serial Monitors like PuTTY or the terminal in CCS 6. I did reinstall the EZ-430 UART drivers. I tried every COM that is listed. The Baud rate is set to 9600 in both script and serial Monitor. The script I tried is following: void setup() { Serial.begin(9600); } void loop() { Serial.println("Hello"); } The board core in Energia is updated to version 1.0.3 and the right board is selected. I hope you have some more solutions, I am going to collapse soon! Sincerely, buerni
×