Jump to content

Aconicks

Members
  • Content Count

    3
  • Joined

  • Last visited

  1. Thank you so much! This seems to solve the problem and the code does run immediately!
  2. Thank you for replying. I have tried both the reset button and disconnecting/reconnecting the device. On both scenarios the outcome is the same. The program starts executing after a long delay on Energia and immediately on CCS. The code I ran on CCS and Energia are not identical since these are different softwares but both the separate codes are the blink example codes provided with each environment without any changes on my side (just import the example project and run). The codes are the following: CCS blink example: #include <msp430.h> int main(void) { WDTCTL = WDTPW | WDTHOLD; // Stop watchdog timer P1DIR |= 0x01; // Set P1.0 to output direction for(;;) { volatile unsigned int i; // volatile to prevent optimization P1OUT ^= 0x01; // Toggle P1.0 using exclusive-OR i = 10000; // SW Delay do i--; while(i != 0); } return 0; } Energia Blink Example: // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(RED_LED, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(RED_LED, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(RED_LED, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second } I assume that since the codes both do essentially the same thing (Maybe up to the time between blinks) they are pretty much identical in their core (under the different native syntax and libraries) so I really don't see why there would be any difference on execution. I have also tried creating an Energia Sketch in CCS but it told me that it doesn't support my chip, which is weird, considering I am able to run Energia code separately. If I can provide you with any more information let me know.
  3. Hello, I am experiencing a frustrating problem which I couldn't find an answer to anywhere online so far, I apologize if a related question was posted before and I didn't find it. I have TI MSP-EXP430G2 Launchpad with an MSP430G2452 on it and I'm trying to upload a basic program (the Blink example) with Energia. After the program has been successfully uploaded the program is not run immediately on the chip and the led doesn't start blinking. Instead there is a long delay (30sec to a few minutes) between powering the device on and the start of the execution. There don't seem to be any errors on compilation/upload. On the other hand, I have tried using Code Composer Studio instead and there the program starts running immediately without any problems. I would really appreciate if anyone has some idea what could be the problem. Thanks in advance.
×
×
  • Create New...