HI you guys
I am trying to connect a Lonet 808(gsm/gps) to my Sensor Tag(cc2650) via a groove connector mounted on the DevPack. I think this will make the ultimate IoT device
The first problem I am having is changing the Uart to use the SDA SCL as TX RX on groove3. As I can see, the hardware should allow for this change but my understanding of the software is not enough to figure out how to do this.
So my questions are:
1. How do I change which pins UART use for communication? (I am trying to modify the UART echo example)
2. Is there any limitations on how many different UART port
