Jump to content

scotto18

Members
  • Content Count

    3
  • Joined

  • Last visited

  1. FWIW, I did eventually solve this problem with the help of John Aldwinckle and now my MSP432's work fine on Windows XP. The answer was given here on the TI forums: http://e2e.ti.com/support/microcontrollers/msp430/f/166/p/460560/1711065#1711065 In case the link above fails, here was the answer given by John:
  2. It's not that I can't locate the drivers - it's that they won't install successfully. And its Windows XP 32 bit. FWIW, have reloaded Energia16 on my Mac and it is now back to working OK - obviously my threat to try the beta CCS on the Mac was enough to pull Energia into line. So at least I am up and running. Will continue to investigate XP driver problem. Scott
  3. I am trying to connect my MSP432 LP to a WIndows XP computer (having given up on using the Mac due to ongoing USB comms connection problems). I have downloaded and installed the driver package as instructed (XDS110_drivers.zip). The driver installation says it was succesful however when I plug in the LP for the first time, installation of the TI debug probes driver(s) fail. The comm ports drivers install correctly. During the driver installation these messages are shown: "Cannot Install the Hardware There was a problem installing this hardware: XDS110 (02.02.04.00) with CMSIS-DAP An error occured during the installation of the device A service installation section in the INF is invalid" Following this, in the Windows Device Manager, there are two devices listed as "XDS110 (02.02.04.00) with CMSIS-DAP", under "Texas Instruments Debug Probes", with yellow exclamation marks. Properties for both devices show that the driver is not installed. There are also 2 XDS110 COMM ports that are installed correctly. I have tried this with two LP's, and two different XP computers and get the same result. It therefore looks like there is a bug in the driver INF file somewhere. Can anyone help? Am currently at a production standstill. Scott MORE INFO: when I try to upload a project in Energia16, I get the orange error message at the top of the console that says: "the selected serial port Failed: Failed to evaluate GEL_Connect(). Connect failed does not exist or your board is not connected" In the console it says: "Failed: CS_DAP_0: Error connecting to the target: (Error -260 @ 0x0) An attempt to connect to the XDS110 failed. ... " It then it goes on about firmware updates might be needed. I feel that the driver not installing correctly is more likely to be the problem and from other reading, updating the firmware seems like it may cause other problems. In the
×
×
  • Create New...