Jump to content
43oh

DanielB33

Members
  • Content Count

    5
  • Joined

  • Last visited

  1. Problem Solved. (No need to rs-232 interface to be connected)
  2. Thanks for the post. Not sure why the guy posted any code though, that would be a very dumb way to set the clocks up.
  3. Sorry, after reading through some posts I noticed that I clearly posted into the wrong section!
  4. I have a PCB with identical usb peripheral hardware as used with STM32F10 E Eval demo board. (I designed this 'identical' board). My device enumerates just fine, but I still get a "USB Device Not Recognized" message. Under device manager (of course) I see "Unknown Device." When I load the same software into the eval board it works fine. My only conclusion is that I NEED the usart connection physically on the board? I am only using this program to communicate with hyper terminal with my pc, not as a link between two PC's. I ONLY need to communicate from my micro to one PC via USB, so I did n
  5. I have a PCB with identical usb peripheral hardware as used with STM32F10 E Eval demo board. (I designed this 'identical' board). My device enumerates just fine, but I still get a "USB Device Not Recognized" message. Under device manager (of course) I see "Unknown Device." When I load the same software into the eval board it works fine. My only conclusion is that I NEED the usart connection physically on the board? I am only using this program to communicate with hyper terminal with my pc, not as a link between two PC's. I ONLY need to communicate from my micro to one PC via USB, so I did n
×
×
  • Create New...