Jump to content


  • Content Count

  • Joined

  • Last visited

Everything posted by ClydeTombaugh

  1. Hi, I'm running Energia on Windows 7 x64. My Launch Pad model is the MSP-EXP430F5529LP (25Hz) My board's green LED will light up when connecting to the computer, the red LED will flash while compiling and all onboard LEDs and buttons function when programed. However, whenever I try to program output pins and connect the output in question to ground, I get no current out. I have plenty of experience with Arduino and all programs I write for the Launch Pad work for Arduino. The GND, 5V and 3.3V pins on the LaunchPad all work fine. I have also used a number of sample programs, all to no avail. Here is a schematic sheet for my model. http://energia.nu/img/LaunchPadMSP430F5529.jpg Here is a quick program that I have written to demonstrate one way that I have been testing it. const int led = 19; // LED is hooked to P2.0 aka 19 with at 220 Ohm resistor and then connected to ground. void setup() { pinMode(led, OUTPUT); } void loop() { digitalWrite(led, HIGH); //LED should turn on and quickly flash off and on again delay(1000); //I know for sure that the LED is not broken because I digitalWrite(led, LOW); // repeatedly test it with my Arduino between compiling delay(500); }
  • Create New...