Jump to content

psiddaveer

Members
  • Content Count

    5
  • Joined

  • Last visited

  1. I have a CC2531 usb dongle.. I want to use it as a Zigbee transceiver. I have used the ZNP as it was in Zigbee stack. what changes do i need to make to this given ZNP to use it as a zigbee transceiver? and how do I print the Received messages on computer screen? Do i use Hyperterminal or some other application? and if Hyperterminal then how? Thankyou
  2. Hi guys, I have two cc2531 modules, 1 I am using as only receiver so I think I can directly use it through packet sniffer to receive.. But on the transmitter side how do I configure my cc2531 as a transmitter?? I am using msp430g2553, so hardware uart and I am using energia to program it.. So can u guys please help me out in configuring cc2531.. And do I compulsorily need to use an external clock of 32.768KHz to get 9600 baud rate?
  3. Hi guys, I have two cc2531 modules, 1 I am using as only receiver so I think I can directly use it through packet sniffer to receive.. But on the transmitter side how do I configure my cc2531 as a transmitter??
  4. Thank you guys thank you for replying.. I was using an array of strings which were used as variables, now when I declared them as constant the ram is free now.. But I need to think of some other way to tick mark the particular index number of the particular array.. And also I need to transmit these strings serially.. So any suggestions for tick marking other than using 1 more array of type int ??
  5. Hi guys, I'm trying to program my msp430g2553 using energia. My program is about 360 lines in arduino.. When I try to compile the code in energia, it shows errors that the ram is insufficient and about 834B more needed.. I can't reduce the no of variables and the only header I've used in liquidcrystal.h.. So is this a problem with program or I need to change the controller?
×
×
  • Create New...