Jump to content
43oh

Leaderboard

Popular Content

Showing content with the highest reputation on 10/20/2020 in all areas

  1. Yes, of course you can do that. Just for the Launchpad the numbering is always done on the boarder of the PCB = Pin Headers of the board, as this is the point where a typical user would connect something. If you prefer for your own board to have the device pin numbers used - you can do that. Doing the updates as you mentioned above should do that 🙂 To get the board in the GUI you need to - add a device in the variants folder - as just discussed with the update of the pins_energia.h file - add a section into the boards.txt file (located in the folder above) in a s
    1 point
×
×
  • Create New...