Jump to content
43oh

Leaderboard

Popular Content

Showing content with the highest reputation on 06/18/2020 in Posts

  1. EMT low power unfortunately is not well documented but quite simple. How low of a power the device goes into depends on what interfaces are open and what device the Sketch runs on. The quick reference: If all Sketches are in delay() the idle loop is entered. The idle loop is a TI-RTOS task that consults the power manager and then determines what level of low power it can go to. Make sure that all unused pins are in the appropriate state according to the datasheet. Usually this is output high. Make sure that sensors that are connected are put into sleep mode if you intend to go to low p
    1 point
×
×
  • Create New...