Jump to content
43oh

Leaderboard

Popular Content

Showing content with the highest reputation on 07/01/2017 in all areas

  1. maelli01

    Solar power display

    An output power display for my solar system. G2553 Launchpad, Blue 4-digit LED display, RS485 Transceiver SN65HVD12P (a low power, 3.3V version of the standard SN75176), this is all there is. All pins are used, 4 + 7 for the multiplexed LEDs (no resistors: Blue LED, 3.6V supply, output resistance of the pins limit the LED current) 3 pins for UART and send/receive for the SN65. 2 pins for 32768Hz xtal (I had this one soldered in on the LP, so why not use it) The MSP asks the inverter over RS485/Modbus "what is your current output power". After less than half a se
    3 points
  2. Finally got around to coding a bootloader for this project. I'm posting version 0.1 here for reference. Lots of times people seem to have trouble with bootloaders (I put off writing one for ages) But this should show you can start simple, and optimise later. The code right now is very rough. But is written in a way that could allow updating of itself it the help of a bootstrap Application. ie: Load new application which when run loads a new bootloader. This bootloader isn't 100% fool proof, if a bad app is loaded that fails to perform as a USB MSC then the user cannot use the USB por
    2 points
×
×
  • Create New...