Sign in to follow this  
Followers 0
zborgerd

MSP-FET Backchannel UART.

2 posts in this topic

Just got my half-price MSP-FET in the mail today.  MSP-FET Backchannel UART support was added in MSP Debug Stack 3.4.1.0.  The firmware version and driver versions match this on my system.

 

I default my terminal (Linux) to 9600 bps and this is normally fine with the FR5969 and F5529 Launchpad built-in EZ-FET.  However, when I use the MSP-FET on the 5969 LP, I have to bump the speed of the port up to something higher and back down to 9600 before data begins to pass correctly.  Has anyone else observed this?

 

Again, the EZ-FET on the same FR5969 LP is fine.  When I switch to the JTAG header with the MSP-FET, the behavior is different.

 

There seem to be some differences in the UART behavior on the EZ-FET vs the MSP-FET.

oPossum likes this

Share this post


Link to post
Share on other sites

Hello zborgerd,

 

even this thread was never answered and is a bit old.

 

I was close to give up on a MSP2553 on a bredboard and using the MSP-FET with uart backchannel @ 9600.

It never worked for no reason, even connecting ping 14 and 12 directly.

found your topic and indeed, switching to 115200, it magically works.

not to bad switching the MCU to 115200, however, one may get some grey hairs not knowing about this "bug?".

 

ps: i used ccs 7.0.0 on linux.

 

best regards

Peter ;-)

oPossum likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0