• Announcements

    • bluehash

      Forum Upgrade   03/11/2017

      Hello Everyone, Thanks for being patient while the forums were being fixed and upgraded. Please see details and report issues in this thread. Thanks!
JayantArora

MSP430G2201

1 post in this topic

I would like to seek help in programming MSP430G2201.

That I am new to MCU field and it is my  first attempt to work with these, I have used Launch Pad to program some flash on other MCU but while trying to do on MSP430G2201 I have not succeeded. My trial is enumerated below.

I am using Launch pad to program MSP 430G2201 using TIDA-00386 remote code.

Upon Build when I click on Debug message as below appears. 

 

Error connecting to the target:

Could not find device (or device not supported)

 

I have connected Vcc, Gnd, RST and TEST pins of 2201 to the Launch Pad J3. I checked and confirmed correct connections offor Vcc and Gnd  on Pin # 14 and 1 of 2201 and so also the RST and TEST are connected correctly..


I have tried the above with CCS version 7 and earlier with version 6.2.

 

Target device is correctly configured as MSP430G2201 in CCS, USB port is also configured.

 

I have attached herewith two snap shots of wave forms of RST (Purple trace, channel 6 ) and TEST ( Grey trace channel 7). Both signals swing between 3.6 V and ground.

 

I seek you help so as to know where I may be going wrong.

 

Thanking you in anticipation.

J. A.

 

debug-start.JPG

 

debug-before-error-message.JPG

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now