Search the Community

Showing results for tags 'measurement'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • Announcements
    • Suggestions
    • New users say Hi!
  • Spotlight!
    • Sponsor Spotlight
    • Sponsor Giveaways
  • Energia
    • Energia - MSP
    • Energia - TivaC/CC3XXX
    • Energia - C2000
    • Energia Libraries
  • MSP Technical Forums
    • General
    • Compilers and IDEs
    • Development Kits
    • Programmers and Debuggers
    • Code vault
    • Projects
    • Booster Packs
    • Energia
  • Tiva-C, Hercules, CCXXXX ARM Technical Forums
    • General
    • SensorTag
    • Tiva-C, Hercules, CC3XXX Launchpad Booster Packs
    • Code Vault
    • Projects
    • Compilers and IDEs
    • Development Kits and Custom Boards
  • Beagle ARM Cortex A8 Technical Forums
    • General
    • Code Snippets and Scripts
    • Cases, Capes and Plugin Boards
    • Projects
  • General Electronics Forum
    • General Electronics
    • Other Microcontrollers
  • Connect
    • Embedded Systems/Test Equipment Deals
    • Buy, Trade and Sell
    • The 43oh Store
    • Community Projects
    • Fireside Chat
  • C2000 Technical Forums
    • General
    • Development Kits
    • Code Vault
    • Projects
    • BoosterPacks

Calendars

There are no results to display.


Found 2 results

  1. The example msp430fr5994x_lpm4-5_02.c is supposed to show how little current is used in this mode. In the file it says: // MSP430FR5x9x Demo - Entering and waking up from LPM4.5 via P1.3 interrupt // with SVS disabled // // Description: Download and run the program. When entered LPM4.5, no LEDs // should be on. Use a multimeter to measure current on JP1 and // compare to the datasheet. When a positive voltage is applied // to P1.3 the device should wake up from LPM4.5. This will enable // the LFXT oscillator and blink the LED (on P1.0). Even for a high-end multimeter this current is too low to be accurately measured. So I helped myself this way: - power the processor from the supercap - a 10k resistor with two antiparallel diodes act as a shunt, - connect the volt meter across the supercap, not across the processor 0.43mV over a 10k resistor gives 43 Nanoamps. (!) Yes, the datasheet (page 32) is right, typical value at 25°C is 45nA. A CR2032 (200mAh) cell would allow the processor to wait for an interrupt for 530 years.
  2. Hi. Need a quick answer for this one please. I need to measure the StateOfCharge of a battery, preferably via the ADC (don't know if there are any other options). The SOC is going to decide whether to initiate charging or end charging, in another program that is already made. Would love a code example! Thx in advance Jais