Search the Community

Showing results for tags 'ccs 6.2'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • Announcements
    • Suggestions
    • New users say Hi!
  • Spotlight!
    • Sponsor Spotlight
    • Sponsor Giveaways
  • Energia
    • Energia - MSP
    • Energia - TivaC/CC3XXX
    • Energia - C2000
    • Energia Libraries
  • MSP Technical Forums
    • General
    • Compilers and IDEs
    • Development Kits
    • Programmers and Debuggers
    • Code vault
    • Projects
    • Booster Packs
    • Energia
  • Tiva-C, Hercules, CCXXXX ARM Technical Forums
    • General
    • SensorTag
    • Tiva-C, Hercules, CC3XXX Launchpad Booster Packs
    • Code Vault
    • Projects
    • Compilers and IDEs
    • Development Kits and Custom Boards
  • Beagle ARM Cortex A8 Technical Forums
    • General
    • Code Snippets and Scripts
    • Cases, Capes and Plugin Boards
    • Projects
  • General Electronics Forum
    • General Electronics
    • Other Microcontrollers
  • Connect
    • Embedded Systems/Test Equipment Deals
    • Buy, Trade and Sell
    • The 43oh Store
    • Community Projects
    • Fireside Chat
  • C2000 Technical Forums
    • General
    • Development Kits
    • Code Vault
    • Projects
    • BoosterPacks

Calendars

There are no results to display.


Found 1 result

  1. I would like to seek help in programming MSP430G2201. That I am new to MCU field and it is my first attempt to work with these, I have used Launch Pad to program some flash on other MCU but while trying to do on MSP430G2201 I have not succeeded. My trial is enumerated below. I am using Launch pad to program MSP 430G2201 using TIDA-00386 remote code. Upon Build when I click on Debug message as below appears. Error connecting to the target: Could not find device (or device not supported) I have connected Vcc, Gnd, RST and TEST pins of 2201 to the Launch Pad J3. I checked and confirmed correct connections offor Vcc and Gnd on Pin # 14 and 1 of 2201 and so also the RST and TEST are connected correctly.. I have tried the above with CCS version 7 and earlier with version 6.2. Target device is correctly configured as MSP430G2201 in CCS, USB port is also configured. I have attached herewith two snap shots of wave forms of RST (Purple trace, channel 6 ) and TEST ( Grey trace channel 7). Both signals swing between 3.6 V and ground. I seek you help so as to know where I may be going wrong. Thanking you in anticipation. J. A.