• Announcements

    • bluehash

      Forum Upgrade   03/11/2017

      Hello Everyone, Thanks for being patient while the forums were being fixed and upgraded. Please see details and report issues in this thread. Thanks!

Leaderboard


Popular Content

Showing most liked content on 03/19/2017 in all areas

  1. 7 likes
    This project was put on hold over the holidays. It's always a busy time, plus the club doesn't hold meets over summer. But I have just completed another 10 units. More of the same, but thought you guys might enjoy some more photos. I couldn't get the same batteries as the last batch, which were 650mAh, these have much smaller 220mAh. But this still provides about 4 hours of run time. The uBlox GPS modules are a huge improvement. Even without the SAW filter in the RF path and the sub-optimal PCB size compared to the antenna. These find more GPS satellites faster than the G.top modules, plus they also use glonass which doubles the visible satellites.
  2. 4 likes
    I have done both of these tasks for more than one client. The 1-Wire protocol speed ends up being about 15kHz, which is slow but reliable. It's really cool to see on an scope though. I developed the I2C slave code using the sample TI code as the starting point. Here are the research materials that I referred to while writing my I2C code: http://www.nxp.com/documents/application_note/AN10216.pdf http://www.nxp.com/documents/user_manual/UM10204.pdf http://i2c.info/i2c-bus-specification http://www.ti.com/lit/an/slva704/slva704.pdf My slave code just follows the logic of the transaction.
  3. 3 likes
    Came across this while browsing. MSP430 Analog Gauge Clock